![]() Data from the RadioReference database that has been flagged for rebanding can be utilized by this scanner (PRO-18, PRO-107).Firmware changes and/or a custom table can be utilized to support rebanding.Rebanding changes can be applied via a custom table but no firmware changes are applicable (PRO-96, PRO-2096).A version of this scanner is rebanding compatible, but cannot be modified (i.e.YES - means one of the following conditions is true (see the superscript).The following convention should be used for specifying whether a trunktracker is Rebanding capable or not.We have a whole range of EL Wire, EL Tape and many types of driver/inverters are also available.Specific questions on these scanners can be directed to the Radio Shack Forum at Radioreference be sure to look at the articles first.įor software recommendations, USB cables, tips and shortcuts, see the appropriate section in the scanner's article or the Programming Your Radio Shack Scanner article. The EL Panels and EL Tape is paper thin (about 1/3 of a millimetre!) so it is incredibly versatile and can be used for a variety of uses If you are creating an EL Backlight where there wasn’t one before you will need to also insert a small inverter/driverĬomprehensive instructions for replacing backlights are available on YouTube We have plenty of other shaped EL Tapes and Panels if this one is not quite right in our storeĮL Tape and Panels need an Inverter to make them glow – if you are replacing an EL Backlight then you simply wire the EL Panel into the inverter that is already in the machine Light Blue (Tron Blue), Deep Blue, Pink, Red, Orange, Yellow and White These Electroluminescent Tape backlight panels are available in: There is a jumper connection on the left and on the right is thin FPC tape that can also easily be soldered onto – just cut off the one you don’t need There are a choice of connectors on either end depending what is most convenient for the device It has been designed to fit most Realistic scanner models but will also backlight any device with similar screen sizeġ2cm may be too long for most models, so just cut it down to size with sharp scissors and reseal ‘cut’ edges with glue before installing. ![]() ![]() This EL Panel is 25mm wide (with a lit area of 23mm) and 120mm long.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |